- April 5, 2005
Pittsford, NY. Easy-Step™ 3000 is an advanced stepper motor drive and control system that provides an easy way to control unipolar stepper motors up to 35V and 3 Amps per phase with sophisticated features. Easy-Step™ 3000’s small size and large capabilities make it ideal for incorporating in robots and other industrial control equipment – it also turns you into an instant motor control expert!
Easy-Step™ 3000 - only 63.6 x 26.4 mm - can drive unipolar stepper motors in full 2-phase, full 1-phase and half-step modes using an easy-to-use command set. Four modes of operation are supported:
- Direct Command Set (via PC serial connection)
- Slave/Remote - Pulse Mode (Step and direction pin inputs)
- Voltage Mode (Analogue Voltage pin input)
- Teach Mode (via PC serial connection)
Easy-Step™ 3000 offers a host of advanced motor control capabilities, such as: store
and replay, smooth acceleration, selectable pull-in rate and maximum step rate,
adjustable ramp time to suit varying loads/motors/operating voltages, Separate
winding supplies to allow "forcing" resistors, demo and set-up/control software,
current position register +⁄– 100,000,000,000 steps, home and mark position
registers, absolute and relative move commands, busy logic output, as well as
the ability to stop with motor coils on or off.
Easy-Step™ 3000
Starter Package is available from stock and includes: ES3000 Stepper Motor
Controller, PC serial cable, PC ISP (Interactive System Programmer), User
Reference Guide, Serial Communications Protocol software.
|
|
|