TekBox EMCview PC Software

Note:  If this software purchase is to be used with an existing Rigol or Siglent spectrum analyzer, please provide the model and serial number in the comments field during order checkout. 

EMCView PC Software For EMC Pre-compliance Testing   

Tekbox EMCview is PC-compatible software for simplifying the process of EMC pre-compliance testing of radiated and conducted emissions. It complements a pre-compliance setup of a spectrum analyzer with TekBox LISNs (Line Impedance Stabilization Networks) and EMI-quiet TEM (Transverse ElectroMagnetic) Cells.  Built-in amplitude correction provides correction and conversion coefficients for cables, amplifiers, attenuators, LISNs, TEM cells, antennas, RF current probes, striplines and capacitive coupling clamps.

Without any time-consuming setup the software is ready for measurements immediately after installation on a PC. All emission related CISPR-xx (EN550xx) measurements and also some automotive manufacturer standards are pre-configured in corresponding project files.  The resulting graph supports two complete measurement runs, such as Average / Quasi-Peak or Peak / Quasi Peak or alternatively a fast Quasi-Peak scan of critical peaks.

Tekbox EMCview software currently supports Rigol, Siglent, R&S FPC and FPH series spectrum analyzers, which should preferably be equipped with the manufacturer’s “EMI option”.  Although preferred, EMCview does not essentially require the EMI option to be installed in the spectrum analyzer; if it is not installed, the analyzer will change all preconfigured resolution bandwidths of 200Hz, 9kHz or 120kHz (as specified in the EMC standards) to 300Hz, 10kHz or 100kHz instead.

Support for other spectrum analyzer manufacturers will be added in future software versions.