Microwave Signal Generator Dual Channel - SynthHDManufacturer: Windfreak Technologies This product is superseded by the SynthHD (v2)
The Windfreak SynthHD RF Signal Generator brings in a new era of low cost high definition Microwave Signal Generation. The amazing yet economical SynthHD: 54MHz – 13.6GHz Dual Channel RF Signal Generator with Software GUI. You can step the output frequency by 0.1Hz steps! And the output level from -50dBm to +20dBm in 0.01dB steps! Shift phase in 0.01 degree steps! You can set each channel independently. Modulation? How about Pulse, AM, and FM including FMCW radar chirp! Complete Labview GUI source too! SynthHD Software GUI (Labview source code included with purchase)
The video below is taken with both channels driven into a mixer. The mixer is then fed into an oscilloscope and displayed on the right side of the video. The signal shows the DC and near DC downconverted component. The DC level depends on the phase relationship between the two channels. The switch on the far right of the GUI toggles between controlling channels (RFA or RFB). For orders over 10 units discounts will apply, please request a quote. |
|||
Customers who purchased this product, also purchased...
|
