IO-Warrior56 Starter Kit (IOW56KIT2)

IO-Warrior56 Starter Kit features a large breadboard area, designed specifically for the IO-Warrior56. The kit allows you to easily make your first steps with IO-Warrior56.  The starter kits are shipped mostly assembled, only the two jumper headers need to be soldered to the board.  Closing J1 connects the LED to P7.7. Since this is also the PWM output it can provide a simple feedback to check the PWM settings. The three pin jumper allows to select the power setting. It connects a 100 kΩ resistor on P6.0 to either Gnd or +5 V to select low or high power to be requested via USB. Solder jumper J2 connects a 1 μF capacitor from AGnd to P2.4 to stabilize the internal analog reference for the A/D converter. The button is connected to P7.0 to generate an input signal for testing.