![]() AmpNV RF Power Amplifier 1 WATT 50MHz-6GHzManufacturer: Windfreak Technologies This product is discontinued. Please view other RF Amplifer options.
Shown below, the software is eloquently engineered giving professional performance at a fraction of the cost of a bench top power amplifier. RF Power Amplifier Gain Control tab. (0dB (max) setting has total device gain of up to +35dB. You can also power down the PA when not in use to save energy and reduce heat.) RF Power Amplifier Extras tab. (Program non-volatile memory and poll for AmpNV pushbutton changes.) RF Power Amplifier Device Read. (Allows a developer to read device settings including voltage rails and temperature.)
The software is easy to install and use. It can control multiple devices based on factory programmed serial numbers.This software was written in Labview and the open source code is included so that you can modify and enhance any way you see fit for your own use. Please do not distribute. If you don't own Labview, you will also get an executable that will install standalone and run on a PC. If you want to write your own software, it is best to get Labview and reverse engineer the Windfreak Labview source code. Labview is available with a free 1 month trial from National Instruments. All source code is sent on CD "saved as" using the latest version of Labview Basic. For programmers, the device is easy to talk to via 1 simple command character followed program data. For example, setting gain is done by opening the COM port and sending the characters "a63" (without the quotes) for max gain (around 30dB) or "a0" for minimum gain, and then closing the COM port. The amplifier runs off of DC power in the range of 15 - 28V and draws around 5 watts. Dimensions are 2.75Wide X 2.15Deep X 1.95Tall inches or 7.0Wide X 5.46Deep X 4.95Tall cm not including mounting tabs and connectors. Warning: While the amplifier is very robust and can handle quite large reflections, it is possible that the output can be harmed if operated at full power into a poor load. There is no output protection. Please verify that your load is 50 ohms in the band that you will be operating. This failure is not covered under warranty. You can also control the gain and turn on and off the PA via the push buttons on the device. The LEDs have variable brightness which gives you a good idea about what gain setting the device is at. Compare this unit to other solutions at higher costs. The AmpNV has better performance and many more features. We've also invested hundreds of man hours on open source software that you get to build upon for highly custom applications. Some applications include: wireless communications systems, microwave point to point backhaul radios, Software Defined Radio (SDR), radar,Automated Test Equipment (ATE), EMC - radiated immunity pre-compliance testing, electronic warfare (EW) and hobbyist radio development. For orders over 10 units discounts will apply, please request a quote. |
|
Customers who purchased this product, also purchased...
|